This page explains how to start and stop ADx and Conversion. The procedure is the same for both services.
Change directory to the installation directory. When you run
ll, the result should be similar to the list below:
_update/ conf/ modules/ plugins/ runtime/ storage/
Change directory to
cd runtime/host/bin). This directory contains the
tribefire-console-stop.shscripts, used to start and stop ADx and Conversion.
./tribefire-console-start.shto start the service. You should get
Tomcat startedresponse and the service should be available shortly (in less than a minute). If the service is not available, please check the
installation_directory/../logs(unless configured otherwise).
./tribefire-console-stop.shto stop the service. You should get
Tomcat stoppedresponse. Note that the services (especially ADx) sometimes take several minutes to stop. In this case, you will get the following warning:
./tribefire-console-stop.sh ... Tomcat did not stop in time. PID file was not removed. To aid diagnostics a thread dump has been written to standard out. Tribefire Host stopped.